Ultra-compact axial roof fans TACC ≤45000 m³/h

• TACC - extremely compact and highly efficient, axial roof fans for blowing out more polluted air and steam from medium and large rooms

• TACC are designed to be easy to install, high efficiency, low noise

• reversible - can be used for air intake

CONSTRUCTION

• base frame made of galvanized steel sheets

• steel guard made according to UNI 10615 standards and weatherproof made according to UNI10615 standard

• body made of galvanized steel sheets covered with epoxy coating

• axial impellers with aerodynamic profile blades made of reinforced glass polyamide, characterized by high efficiency and low noise level, balanced according to ISO1940. Variable angle of inclination in a stationary position with the possibility of adjustment

• upper body protection made of ABS plastic (models 4500-630), made of fiberglass (models 710-900)

ENGINE

• asynchronous three-phase motors with bearings, protection class - IP55, complies with standards EC 60034, IEC 60072, EMC 2014/30/UE, LVD 2014/35/UE, CE marked, suitable for S1 operation (continuous operation under constant load)

• the fan can transport air with a temperature of up to -15 - +50 °C

ACCESSORIES

• CCda gravity shutters

(see manufacturer's catalogue page for detailed dimensions and parameters)

• CB metal base for fixing to concrete. With special fixing brackets. Solid construction for attachment to the fan pad

(see manufacturer's catalogue page for detailed dimensions and parameters)

• BA roof fan mounting pads for installation on corrugated surfaces

The BA support pad with transition RD is suitable for mounting roof fans on undulating surfaces, helping you to avoid damaging water stagnation near the fan and costly labour for installers. The BA support base is suitable for roof fans with a base size of 930 mm x 930 mm or larger. With the use of a suitable transition RD, the base can be used for roof fans with a minimum base dimension of 500 x 500 mm. The RD transition is a one-piece unit that can be easily cut to the exact dimensions of the fan.

Versions
- BA 10x177 (code 5PL1008): suitable for EURO roofs with a wavelength of 177 mm, a height of 51 mm and a slope of 10%
- BA 3x177 (code 5PL1015): suitable for EURO roofing with a wavelength of 177 mm, a height of 51 mm and a sheet radius of 3 metres
- BA 10x146 (code 5PL1009): suitable for INTERNATIONAL roofing with a wavelength of 146 mm, a height of 48 mm and a slope of 10%
- transition RD (code 5PL1010)
Made of polyester resin, reinforced with laminated glass fibre. Finish RAL 9002 (light grey). Outer surface treated against atmospheric agents. When properly installed, an overlay with an overlay plate downstream and insufficient overlay upstream is foreseen. In addition, at least one and a half quarter waves of lateral overlap on each side shall be provided.

• PB - roof panel with acoustic base for mounting roof fans on a flat roof covering. Made of galvanised steel with acoustic insulation infill

(see manufacturer's catalogue page for detailed dimensions and parameters)

• CCrc - conical grille (the narrower part is mounted on the motor)

• speed controller, please choose fan model you wish to purchase and contact us to find the right one

• made in Italy

• 2 years warranty

Technical information

Manufacturer's catalog page