Low-capacity, high-pressure centrifugal fans for hot air and fumes, up to 150 °C, with a forward curved impeller DIC AT ≤2500 m³/h

• DIC AT - centrifugal fans of the series are designed to transport clean and dust-free air and smoke with a temperature of up to +150 °C. They are suitable for all industrial applications where small air volumes and high pressures are required. The series consists of different models with impeller diameters from 100 to 180 mm. The motor is directly attached to the forward curved impeller. The housing is easily adjustable to the desired discharge angle in 45° increments, including 180° and 225° positions

• other modifications of the DIC series fans:

1. DIC - centrifugal fans of the series are designed to transport clean and dust-free air and smoke with a temperature of up to +100 °C

2. DIC INOX - centrifugal fans with stainless steel casing for the transport of corrosive gases or fumes up to +80 °C

3. DIC INOX / AT - centrifugal fans with stainless steel housing for corrosive gases or fumes up to +150 °C only on special order, to be combined separately

4. DIC ATEX - explosion-proof centrifugal fans for the transport of clean air or fumes up to +40 °C

5. DIC INOX ATEX - explosion-proof centrifugal fans with stainless steel housing for the transport of corrosive gases or fumes up to +40 °C

• housing positions (price may vary when ordering with RD housing)::

CONSTRUCTION

• body made of sheet steel, protected from atmospheric effects with epoxy paint
• single inlet, single width forward curved impeller (sirocco type), made of galvanized sheet steel
• execution 5 (with impeller directly connected to motor)
• standard orientation LG270° (rotation RD on request)

INSTALLATION

• centrifugal fans with forward-curved impellers must always be installed in duct systems where pressure resistance is expected (for example, gravity valves or long duct systems)
• it is necessary to estimate the system pressure loss so that the information on the motor nameplate and the pressure loss diagram meet the performance requirements after the system pressure loss assessment

ENGINE

• asynchronous three-phase motors comply with international standards IEC 600034, IEC 60072, EMC 2014/30/UE, LVD 2014/35/UE, CE marked, IP 55, class F, form B35. DIC 100 T and M with motor form B14, IP44, class B

ACCESSORIES

• the air intake and exhaust opening protective grilles are manufactured according to UNI 12499 rules and are protected from atmospheric factors

(see detailed dimensions and parameters on the manufacturer's catalog page)

Exhaust (OUT)	Intake (IN)

• steel engine support made of sheet steel, painted with epoxy resin

(see detailed dimensions and parameters on the manufacturer's catalog page)

• air exhaust connection from rectangular to round

(see detailed dimensions and parameters on the manufacturer's catalog page)

• a round adapter for the air intake is included

(see detailed dimensions and parameters on the manufacturer's catalog page)

• speed controller, please choose fan model you wish to purchase and contact us to find the right one
• made in Italy
• 2 years warranty

Technical information